rfc1995

Network Working Group M. Ohta Request for Comments: 1995 Tokyo Institute of Technology Updates: 1035 August 1996 Category: Standards Track Incremental Zone Transfer in DNS Status of this Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract This document proposes extensions to the DNS protocols to provide an incremental zone transfer (IXFR) mechanism. 1. Introduction For rapid propagation of changes to a DNS database [STD13], it is necessary to reduce latency by actively notifying servers of the change. This is accomplished by the NOTIFY extension of the DNS [NOTIFY]. The current full zone transfer mechanism (AXFR) is not an efficient means to propagate changes to a small part of a zone, as it transfers the entire zone file. Incremental transfer (IXFR) as proposed is a more efficient mechanism, as it transfers only the changed portion(s) of a zone. In this document, a secondary name server which requests IXFR is called an IXFR client and a primary or secondary name server which responds to the request is called an IXFR server. 2. Brief Description of the Protocol If an IXFR client, which likely has an older version of a zone, thinks it needs new information about the zone (typically through SOA refresh timeout or the NOTIFY mechanism), it sends an IXFR message containing the SOA serial number of its, presumably outdated, copy of the zone. An IXFR server should keep record of the newest version of the zone and the differences between that copy and several older versions. When an IXFR request with an older version number is received, the IXFR server needs to send only the differences required to make that version current. Alternatively, the server may choose to transfer the entire zone just as in a normal full zone transfer. When a zone has been updated, it should be saved in stable storage before the new version is used to respond to IXFR (or AXFR) queries. Otherwise, if the server crashes, data which is no longer available may have been distributed to secondary servers, which can cause persistent database inconsistencies. If an IXFR query with the same or newer version number than that of the server is received, it is replied to with a single SOA record of the server's current version, just as in AXFR. Transport of a query may be by either UDP or TCP. If an IXFR query is via UDP, the IXFR server may attempt to reply using UDP if the entire response can be contained in a single DNS packet. If the UDP reply does not fit, the query is responded to with a single SOA record of the server's current version to inform the client that a TCP query should be initiated. Thus, a client should first make an IXFR query using UDP. If the query type is not recognized by the server, an AXFR (preceded by a UDP SOA query) should be tried, ensuring backward compatibility. If the query response is a single packet with the entire new zone, or if the server does not have a newer version than the client, everything is done. Otherwise, a TCP IXFR query should be tried. To ensure integrity, servers should use UDP checksums for all UDP responses. A cautious client which receives a UDP packet with a checksum value of zero should ignore the result and try a TCP IXFR instead. The query type value of IXFR assigned by IANA is 251. 3. Query Format The IXFR query packet format is the same as that of a normal DNS query, but with the query type being IXFR and the authority section containing the SOA record of client's version of the zone. 4. Response Format If incremental zone transfer is not available, the entire zone is returned. The first and the last RR of the response is the SOA record of the zone. I.e. the behavior is the same as an AXFR response except the query type is IXFR. If incremental zone transfer is available, one or more difference sequences is returned. The list of difference sequences is preceded and followed by a copy of the server's current version of the SOA. Each difference sequence represents one update to the zone (one SOA serial change) consisting of deleted RRs and added RRs. The first RR of the deleted RRs is the older SOA RR and the first RR of the added RRs is the newer SOA RR. Modification of an RR is performed first by removing the original RR and then adding the modified one. The sequences of differential information are ordered oldest first newest last. Thus, the differential sequences are the history of changes made since the version known by the IXFR client up to the server's current version. RRsets in the incremental transfer messages may be partial. That is, if a single RR out of multiple RRs of the same RR type at the same owner name and CLASS changes, only the changed RR is transferred.

EID 3197 (Verified) is as follows:

Section: 4, pg.3

Original Text:

|  RRs in the incremental transfer messages may be partial.  That is, if
   a single RR of multiple RRs of the same RR type changes, only the
   changed RR is transferred.

Corrected Text:

|  RRsets in the incremental transfer messages may be partial.  That is,
|  if a single RR out of multiple RRs of the same RR type at the same
|  owner name and CLASS changes, only the changed RR is transferred.

Notes:
Rationale:
DNS resource records (RRs) are always transferred as integral
entities in the DNS protocol, and IXFR is no exception for this
rule. So there never are partial RRs in any IXFR response packets.
However, as indicated more precisely in the adjusted text above,
it is intended that partial _RRsets_ are carried in IXFR responses;
unchanged RRs are not sent inside incremental response messages.
Historical Note:
The above issue has been identified by the submitter in 2008,
but no Errata have been filed so far. However, it already had
been observed in 1999 by Andreas Gustafsson, who, in the context of
the work on RFC 1995bis, recently has provided the DNSEXT WG access
to a privately archived DNSIND mailing list thread on RFC 1995,
in which such issues have been discussed in November 1999.
For the record, the technical issues in RFC 1995 that can be
addressed by Errata Notes are now being submitted this way.

An IXFR client, should only replace an older version with a newer version after all the differences have been successfully processed. An incremental response is different from that of a non-incremental response in that it begins with two SOA RRs, the server's current SOA followed by the SOA of the client's version which is about to be replaced. 5. Purging Strategy An IXFR server can not be required to hold all previous versions forever and may delete them anytime. In general, there is a trade-off between the size of storage space and the possibility of using IXFR. Information about older versions should be purged if the total length of an IXFR response would be longer than that of an AXFR response. Given that the purpose of IXFR is to reduce AXFR overhead, this strategy is quite reasonable. The strategy assures that the amount of storage required is at most twice that of the current zone information. Information older than the SOA expire period may also be purged. 6. Optional Condensation of Multiple Versions An IXFR server may optionally condense multiple difference sequences into a single difference sequence, thus, dropping information on intermediate versions. This may be beneficial if a lot of versions, not all of which are useful, are generated. For example, if multiple ftp servers share a single DNS name and the IP address associated with the name is changed once a minute to balance load between the ftp servers, it is not so important to keep track of all the history of changes. But, this feature may not be so useful if an IXFR client has access to two IXFR servers: A and B, with inconsistent condensation results. The current version of the IXFR client, received from server A, may be unknown to server B. In such a case, server B can not provide incremental data from the unknown version and a full zone transfer is necessary. Condensation is completely optional. Clients can't detect from the response whether the server has condensed the reply or not. For interoperability, IXFR servers, including those without the condensation feature, should not flag an error even if it receives a client's IXFR request with a unknown version number and should, instead, attempt to perform a full zone transfer. 7. Example Given the following three generations of data with the current serial number of 3, JAIN.AD.JP. IN SOA NS.JAIN.AD.JP. mohta.jain.ad.jp. ( 1 600 600 3600000 604800) IN NS NS.JAIN.AD.JP. NS.JAIN.AD.JP. IN A 133.69.136.1 NEZU.JAIN.AD.JP. IN A 133.69.136.5 NEZU.JAIN.AD.JP. is removed and JAIN-BB.JAIN.AD.JP. is added. jain.ad.jp. IN SOA ns.jain.ad.jp. mohta.jain.ad.jp. ( 2 600 600 3600000 604800) IN NS NS.JAIN.AD.JP. NS.JAIN.AD.JP. IN A 133.69.136.1 JAIN-BB.JAIN.AD.JP. IN A 133.69.136.4 IN A 192.41.197.2 One of the IP addresses of JAIN-BB.JAIN.AD.JP. is changed. JAIN.AD.JP. IN SOA ns.jain.ad.jp. mohta.jain.ad.jp. ( 3 600 600 3600000 604800) IN NS NS.JAIN.AD.JP. NS.JAIN.AD.JP. IN A 133.69.136.1 JAIN-BB.JAIN.AD.JP. IN A 133.69.136.3 IN A 192.41.197.2 The following IXFR query +---------------------------------------------------+ Header | OPCODE=SQUERY | +---------------------------------------------------+ Question | QNAME=JAIN.AD.JP., QCLASS=IN, QTYPE=IXFR | +---------------------------------------------------+ Answer | <empty> | +---------------------------------------------------+ Authority | JAIN.AD.JP. IN SOA serial=1 | +---------------------------------------------------+ Additional | <empty> | +---------------------------------------------------+ could be replied to with the following full zone transfer message: +---------------------------------------------------+ Header | OPCODE=SQUERY, RESPONSE | +---------------------------------------------------+ Question | QNAME=JAIN.AD.JP., QCLASS=IN, QTYPE=IXFR | +---------------------------------------------------+ Answer | JAIN.AD.JP. IN SOA serial=3 | | JAIN.AD.JP. IN NS NS.JAIN.AD.JP. | | NS.JAIN.AD.JP. IN A 133.69.136.1 | | JAIN-BB.JAIN.AD.JP. IN A 133.69.136.3 | | JAIN-BB.JAIN.AD.JP. IN A 192.41.197.2 | | JAIN.AD.JP. IN SOA serial=3 | +---------------------------------------------------+ Authority | <empty> | +---------------------------------------------------+ Additional | <empty> | +---------------------------------------------------+ or with the following incremental message: +---------------------------------------------------+ Header | OPCODE=SQUERY, RESPONSE | +---------------------------------------------------+ Question | QNAME=JAIN.AD.JP., QCLASS=IN, QTYPE=IXFR | +---------------------------------------------------+ Answer | JAIN.AD.JP. IN SOA serial=3 | | JAIN.AD.JP. IN SOA serial=1 | | NEZU.JAIN.AD.JP. IN A 133.69.136.5 | | JAIN.AD.JP. IN SOA serial=2 | | JAIN-BB.JAIN.AD.JP. IN A 133.69.136.4 | | JAIN-BB.JAIN.AD.JP. IN A 192.41.197.2 | | JAIN.AD.JP. IN SOA serial=2 | | JAIN-BB.JAIN.AD.JP. IN A 133.69.136.4 | | JAIN.AD.JP. IN SOA serial=3 | | JAIN-BB.JAIN.AD.JP. IN A 133.69.136.3 | | JAIN.AD.JP. IN SOA serial=3 | +---------------------------------------------------+ Authority | <empty> | +---------------------------------------------------+ Additional | <empty> | +---------------------------------------------------+ or with the following condensed incremental message: +---------------------------------------------------+ Header | OPCODE=SQUERY, RESPONSE | +---------------------------------------------------+ Question | QNAME=JAIN.AD.JP., QCLASS=IN, QTYPE=IXFR | +---------------------------------------------------+ Answer | JAIN.AD.JP. IN SOA serial=3 | | JAIN.AD.JP. IN SOA serial=1 | | NEZU.JAIN.AD.JP. IN A 133.69.136.5 | | JAIN.AD.JP. IN SOA serial=3 | | JAIN-BB.JAIN.AD.JP. IN A 133.69.136.3 | | JAIN-BB.JAIN.AD.JP. IN A 192.41.197.2 | | JAIN.AD.JP. IN SOA serial=3 | +---------------------------------------------------+ Authority | <empty> | +---------------------------------------------------+ Additional | <empty> | +---------------------------------------------------+ or, if UDP packet overflow occurs, with the following message: +---------------------------------------------------+ Header | OPCODE=SQUERY, RESPONSE | +---------------------------------------------------+ Question | QNAME=JAIN.AD.JP., QCLASS=IN, QTYPE=IXFR | +---------------------------------------------------+ Answer | JAIN.AD.JP. IN SOA serial=3 | +---------------------------------------------------+ Authority | <empty> | +---------------------------------------------------+ Additional | <empty> | +---------------------------------------------------+ 8. Acknowledgements The original idea of IXFR was conceived by Anant Kumar, Steve Hotz and Jon Postel. For the refinement of the protocol and documentation, many people have contributed including, but not limited to, Anant Kumar, Robert Austein, Paul Vixie, Randy Bush, Mark Andrews, Robert Elz and the members of the IETF DNSIND working group. 9. References [NOTIFY] Vixie, P., "DNS NOTIFY: A Mechanism for Prompt Notification of Zone Changes", RFC 1996, August 1996. [STD13] Mockapetris, P., "Domain Name System", STD 13, RFC 1034 and RFC 1035), November 1987. 10. Security Considerations Though DNS is related to several security problems, no attempt is made to fix them in this document. This document is believed to introduce no additional security problems to the current DNS protocol. 11. Author's Address Masataka Ohta Computer Center Tokyo Institute of Technology 2-12-1, O-okayama, Meguro-ku, Tokyo 152, JAPAN Phone: +81-3-5734-3299 Fax: +81-3-5734-3415 EMail: mohta@necom830.hpcl.titech.ac.jp